Allow Repeat controls whether someone can go through an automation more than once. You’ll find it in the automation’s Settings tab.
Defaults
The default depends on the trigger:
- List triggers (added to or removed from a list) don’t allow repeats, so each person goes through once.
- Form submission triggers allow repeats, since someone can submit a form more than once and each submission should start the automation again.
- Weekly and monthly (scheduled) triggers allow repeats, so the list is included each time the schedule runs.
- Manual triggers allow repeats, so you can run them for the same people again.
You can change the setting for any automation in its Settings tab. When you change an automation’s trigger, Flowforth switches to the new trigger’s default—and if that differs from your current choice, asks whether you want to keep your existing setting or use the new default.
When Repeats Are Off
Each person goes through the automation once. Anyone who has already completed it isn’t started again, whether by its trigger or by Run now.
People whose last run was canceled or failed haven’t completed the automation, so they can start it again. You can also pick up a stopped run where it left off with Retry.
When Repeats Are On
Each new trigger starts the automation again for that person, with a few safeguards so nobody gets the same emails twice by accident:
- List triggers: someone removed from the list and added back starts the automation again, even if they finished it minutes ago. If Planning Center reports the same list change more than once, it only counts once.
- Weekly and monthly triggers: someone who completed the automation in the last 20 hours isn’t started again, so a schedule can’t send to them twice in one day.
- Anyone already partway through isn’t started a second time—this applies across all triggers (list, form, scheduled, and manual). Any new trigger that arrives while their run is still going is skipped rather than queued for later.
When a list change is skipped because someone was partway through, they appear on the automation’s People tab as Skipped, with the reason “Already partway through this automation.” Once their current run finishes, you can start it for them again with Run now, or by triggering it again (such as removing them from the list and adding them back). Last modified on November 20, 2026